Ceritified

ISO9001, CE, TUV ,CB, RoHS

Product Range

5000+ Specifications

Services

ODM & OEM

Blog

An armored cable gland is built for cables with a metallic armour layer—most often steel-wire armour (SWA) or aluminium-wire armour (AWA). Unlike a standard single-compression waterproof gland that only grips the outer sheath, an armored gland must clamp the armour for mechanical retention and, where required, earth continuity, while still sealing the outer jacket against water and dust.

Specifying a normal industrial gland on SWA cable is a common procurement error. The outer seal may look

Read More »

Installing a waterproof cable gland is a short mechanical sequence: match the gland to the cable and entry, seat the elastomer on the outer sheath, tighten to the right torque, and confirm the panel-side seal. Most water ingress after “IP68” glands were fitted comes from installation errors—wrong OD range, seal on the wrong layer, missing washer, or over-/under-torque—not from the part itself.

This guide is a practical step-by-step for single-compression waterproof glands on industrial and outdoor enclosures. For failure diagnosis

Read More »

A solar PV cable gland is the sealed entry where DC string cables, inverter feeds, or monitoring lines pass into a combiner box, junction box, or outdoor inverter enclosure. On rooftop and ground-mount systems the gland must hold an IP rating under rain and dust, resist UV for years, and clamp the correct cable outer diameter without crushing the jacket. Wrong sizing or the wrong material is a common cause of water in combiner boxes and early string faults.

This guide focuses on selection for photovoltaic installations. For general outdoor enclosure logic, see How to Choose the

Read More »
Get A Free Quote